Installation, Startup, and Troubleshooting

The content of this page is a summary of the instruction manual provided with the kit. In case of loss or for convenience, you can refer to this page or download a new copy by clicking here. Installation or replacement of the system must be carried out by qualified personnel.

Safety Instructions

  • Do not disconnect any PV module from the master panel before disconnecting the AC power.
  • Only qualified personnel may install the Ready AC Power photovoltaic system.
  • All electrical installations must comply with local regulations.
  • Before installing and using the Ready AC Power system, carefully read all instructions and advice in the technical documentation.
  • To reduce the risk of burns, do not touch the body of the conversion electronics.
  • Damaging or opening the DC/AC conversion electronics will void the warranty. Contact technical support in case of issues.
  • Grounding connected via the AC connector.
  • Do not connect the DC input when the AC connector is disconnected.
  • Install a protection switch on the AC side of the conversion electronics.

System Introduction

The Ready AC Power system is used for grid-tied interactive applications. It consists of three main elements:

  • Master panel (photovoltaic module with integrated DC/AC conversion electronics)
  • Slave panels (depending on the selected kit power, these are the modules to be connected to the master panel)
  • Integrated Wi-Fi interface for internet connection

If the wireless signal in the area where the master panel is located is weak, a repeater may be needed to ensure stable communication between the master panel and the router.

The master modules interface with single-phase networks. Multiple master modules can be used in single-phase networks to form a three-phase network. The Ready AC Power system is simple to install. The conversion electronics are pre-mounted inside the master panel, reducing the number of connections required.

Need assistance?

Request Support

Solarman autotest

Installation and Startup